Composition of the dry oil from the oil level alkyd resin, red iron oxide, such as anti-rust paint, physical pigments, driers, additives and solvents from the preparation.

Key Features

              * Tough film, with good adhesion

              · Has good anti-rust performance

              * Has good resistance to nitro-based performance, matching with the nitrocellulose paint does not bite the end, do not bleed

              * Easy to polish the film, non-stick sandpaper

              · Good durability under normal climatic conditions, but poor durability under hot and humid conditions

Use Apply to nitro paint or alkyd paint on the surface of iron and steel for primer use.

The appearance of iron red, color uncertain, film formation.

Construction parameters

              Volume of solid 36 ± 3% (GB / T9272 eqv ISO3233: 1998 provisions of the determination)

              Dry film thickness 35mm

              Wet film thickness of 97mm

              The theoretical amount of 137g / m2

              A flash point of 40 ° C

              Drying time (25 ℃)

              Table dry ≤ 2h

              Hard work ≤ 24h

              Drying (105 ± 2 ℃) ≤ 30min

Overcoating interval time

Recommended coating number 2, dry film thickness of 70mm

After the Road supporting the use of paint and various oily nitro-oil, phenolic, alkyd-type finish, alkyd deck anti-skid paint

Surface treatment

              * There are oxide steel: sandblasting treatment to Sa2 level (acid method can also be used to remove oxide and rust)

              * No oxide steel: Elastic grinding wheel grinding to St3 level

              · Steel coated with shop primer: paint film damage and corrosion at the second rust, polished to St3 level

              * Welding, flame cutting or fire correction Combustion: polished to St3 level

Construction conditions

              • Substrate temperature should be above 3 ℃ above dew point

              · Relative humidity not more than 85%

Coating method

Airless spray

          Diluent 104 Diluent

          Dilution 0-5% (by weight of paint)

          Nozzle diameter 0.4-0.5mm

          The discharge pressure is 12 to 15 MPa (about 120 to 150 kg / cm2)

Air spraying

              Diluent 104 Diluent

              Dilution 0-10% (by weight of paint)

              Nozzle diameter of 2.0-3.0mm

              Air pressure 0.3-0.4MPa (about 3-4kg / cm2)

Roll coating / brushing

          Diluent 104 Diluent

          Dilution 0-5% (by weight of paint)

Cleaner 104 Diluent

For safety measures, please refer to the Material Safety Data Sheet (MSDS) of Anhui Kailin New Material Co., Ltd. (formerly Tianchang Kailin Chemical Co., Ltd.).

Packaging 20L barrels 25kg

Shelf life of 12 months

Remark For the correct use of our products, please carefully read the "User's Guide" in this manual.

Statement The above data and data are based on our test and practical experience in the use of accumulated and can be used as construction guide. We do not understand the situation in the construction, we only guarantee the quality of the paint itself, other issues will not be responsible. For this manual, we will be based on the continuous improvement of products have the right to modify.