Composed of alkyd resin, driers, auxiliaries and solvents and aluminum powder composed of two-component topcoat.

Key Features

               * Has a certain heat resistance, can be 200 ℃ temperature long-term use

               · Tough and bright film, with good adhesion

               · Has good weather resistance

               · Good resistance to oil

               * Has good construction performance

Uses For the boiler, steam pipes, radiators and mechanical equipment within the room for the protection and decoration of steel surface.

Appearance aluminum color.

Construction parameters

               Volume solid 30 ± 3% (according to GB / T9272 eqv ISO3233: 1998 provisions of the determination)

               Component A: Component B = 4: 1 (weight ratio)

               Dry film thickness 20mm

               Wet film thickness 67mm

               Theoretical amount of 67g / m2

               A flash point of 35 ° C

               Drying time (25 ℃)

               Table dry ≤ 4h

               Hard work ≤ 24h

               Overcoating interval time

Recommended coating number 2, dry film thickness 40mm.

711 Hongdan oil-based anti-rust paint, 725 red phenolic anti-rust paint, 725 zinc yellow phenolic anti-rust paint, 706 anti-rust paint, C53-41 iron red multi-purpose primer, C53-38 aluminum Rust paint and other oil, alkyd, phenolic primer matching; for 200 ℃ the following high temperature can be painted directly on the steel surface, without coating anti-rust primer.

Surface treatment

              • Before the paint should be completely dry

              • Remove all oil and debris from the paint film

Construction conditions

              · Before use, add aluminum paste in the proportion of paint to stir evenly after 0.2mm (80 mesh) copper wire mesh filter after use

              • Substrate temperature should be above 3 ℃ above dew point

              · Relative humidity not more than 85%

Coating method

Airless spray

          Diluent 104 Diluent

          Dilution 0-5% (by weight of paint)

          Nozzle diameter 0.4-0.5mm

          The discharge pressure is 12 to 15 MPa (about 120 to 150 kg / cm2)

  Air spraying

              Diluent 104 Diluent

              Dilution 0-10% (by weight of paint)

              Nozzle diameter of 2.0-3.0mm

              Air pressure 0.3-0.5MPa (about 3-5kg / cm2)

Roll coating / brushing

          Diluent 104 Diluent

          Dilution 0-3% (by weight of paint)

detergent 

           104 diluent

For safety measures, please refer to the Material Safety Data Sheet (MSDS) of Anhui Kailin New Material Co., Ltd. (formerly Tianchang Kailin Chemical Co., Ltd.).

Packing Group A: 20L barrels 17kg

                 Group B: 4.3L in 4L drums

Shelf life of 10 months

Remark For the correct use of our products, please carefully read the "User's Guide" in this manual.

Statement The above data and data are based on our test and practical experience in the use of accumulated and can be used as construction guide. We do not understand the situation in the construction, we only guarantee the quality of the paint itself, other issues will not be responsible. For this manual, we will be based on the continuous improvement of products have the right to modify.