<address id="9hx9l"></address>
      <form id="9hx9l"></form>
        <form id="9hx9l"></form>

        <form id="9hx9l"></form>


          19-6 L01-21(424)Environmental protection asphalt oil varnish

          Product introduction

          Form :
          Main characteristics :
          Purpose :
          Appearance :

          Composed of petroleum resin, additives and petroleum solvents and other components of the varnish.

          Key Features

                        * Can be dissolved in oil and fuel, does not affect the quality of oil

                        * Has a certain water resistance

                        * Has a certain anti-rust properties

          Application It is suitable for temporary protection of oil tank and fuel oil tank.

          The appearance of orange or brown varnish

          Construction parameters

                        Volume of solid 44 ± 3% (GB / T9272 eqv ISO3233: 1998 provisions of the determination)

                        Dry film thickness of 20μm

                        Wet film thickness of 45μm

                        The theoretical amount of 41g / m2

                        A flash point of 35 ° C

                        Drying time (25 ℃)

                        Table dry ≤ 30min

                        Hard work ≤ 2h

          It is recommended that the number of coating channels 1, dry film thickness 20μm

          Surface treatment

                        Sandblasting treatment to Sa2.5 level

                        · Steel coated with shop primer: the use of sweeping sandblasting, or the flexibility of grinding wheel shop primer

          Construction conditions

                        • Substrate temperature should be above 3 ℃ above dew point

                        · Relative humidity not more than 85%

          Coating method

          Airless spray

                    Diluent of pine

                    Dilution 0-3% (by weight of paint)

                    The nozzle diameter is 0.3-0.4mm

                    The discharge pressure is 15 to 20 MPa (about 150 to 200 kg / cm2)

          Air spraying

                        Diluent of pine

                        Dilution 0-3% (by weight of paint)

                        The nozzle diameter is 1.5-2.0mm

                        Air pressure 0.3-0.5MPa (about 3-5kg / cm2)

          Roll coating / brushing

                    Diluent of pine

                    Dilution 0-3% (by weight of paint)

                    Detergent pine fragrance

          Safety precautions Refer to the MSDS.

          Packaging 20 L drums 16kg

          Shelf life of 12 months


          · The viscosity of this product has been adjusted to the construction needs of the factory, generally do not need to add thinner. In particularly hot or cold season can be adjusted according to the amount of coating solution in the diluent

          · Painting, especially the use of high-pressure spray without air, should pay attention to control the thickness of spray to prevent the occurrence of sagging

          • Ventilation should be carried out in accordance with the amount of ventilation specified in the safety measures

          • This product is slightly muddy sometimes, but does not prevent its normal use

          Remark For the correct use of our products, please carefully read the "User's Guide" in this manual.

          Statement The above data and data are based on our test and practical experience in the use of accumulated and can be used as construction guide. We do not understand the situation in the construction, we only guarantee the quality of the paint itself, other issues will not be responsible. For this manual, we will be based on the continuous improvement of products have the right to modify.

          If you have questions, you can:

          Or leave a message for us.

          Related recommendation
          Online Service




              <address id="9hx9l"></address>
              <form id="9hx9l"></form>
                <form id="9hx9l"></form>

                <form id="9hx9l"></form>