<address id="9hx9l"></address>
      <form id="9hx9l"></form>
        <form id="9hx9l"></form>

        <form id="9hx9l"></form>


          H52-55 amine curing epoxy anticorrosive finish (two-component)

          Product introduction

          Form :
          Main characteristics :
          Purpose :
          Appearance :

          Product composition:

          Epoxy resin, amine curing agent, pigments, additives and solvents composed of two-component epoxy finish.

          Product performance:

          1. Solid content, can be made of thick-film epoxy finish.

          2. Tough film has excellent adhesion, flexibility, wear resistance and impact resistance and other physical properties.

          3. Has excellent alkali resistance.

          4. Has excellent water resistance and salt water resistance.

          5. Has excellent oil resistance and anti-chemical properties.

          6. Has excellent durability and corrosion resistance.

          7. Weatherability slightly worse, after prolonged exposure, the surface will be a slight powder, affecting the appearance, but little effect on the protection.

          Product Usage:

          For epoxy zinc-rich primer and epoxy-iron-iron antirust paint or amine curing epoxy primer on the protection of steel structure as a high-performance paint matching finish, contact with coastal salt gas steel structure, steel Concrete surface and steel structure of the plant, etc. for high-performance protective coating purposes.

          Construction parameters:

          Proportion: Main paint: curing agent = 20: 5 (weight ratio)

          Drying time: (25 ) surface dry 12h, hard work 24h, fully cured for 7 days

          Overcoating interval:

          Substrate temperature




          The shortest









          Application period: 20 8h

          Construction Reference:

          Recommended coating number: 2, dry film thickness 80m, in the concrete surface without primer when the dry film thickness of about 200m is appropriate.

          Before the Road supporting the paint: epoxy zinc-rich primer, epoxy-iron anti-rust paint, iron red epoxy anti-rust paint, amine curing epoxy primer.

          Surface treatment: the paint on the road dry paint and remove all the dirt.

          Note: Construction temperature is lower than 5 , curing reaction is slow, should be appropriate to extend the curing time.

          Construction method: spray, brush or roller

          Thinner: XH-1 epoxy diluent

          Dosage: 0-10% (by weight)

          Packing: Main paint: 20kg / barrel, curing agent: 5kg / pot.

          Shelf Life: 12 months, subject to specified conditions

          Note: For correct use of this product, please carefully read the instructions.

          Disclaimer: The above information and data is accumulated in the experimental conditions and actual use, and can be used as a construction guide. We only guarantee the quality of the paint, for this manual, we will be based on the continuous improvement of products are subject to change without notice.

          If you have questions, you can

          Or leave a message for us.

          Related recommendation
          Online Service




              <address id="9hx9l"></address>
              <form id="9hx9l"></form>
                <form id="9hx9l"></form>

                <form id="9hx9l"></form>